Answer Posted / ashraf
According to the HART Foundation spec, the 1200-2400 Hz HART signal needs a minimum (230 ohm) resistance in the loop to create a HART signal with enough amplitude to meet the sensitivity requirements of a HART modem receiver.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the difference between active & reactive power?
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
What are the uses of orifice plates?
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
What is the start up procedure of desalter
can any send me a forbes marshall dtron 316 manual
what is maxdna ?. explain about the software details.
when a magnet is heated?
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
the output of the common trasmitter protocol in qatar gas are the following
Question on maha cement
Name different types of bourdon tubes.
Explain operation of Haskel pump.