Interested to Buy Any Domain ? << Click Here >> for more details...
What happens if we give ac supply to dc shunt and series
motors individually
- 4 Answers
- 10835 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / ganika
shunt motor won't rotate because alternating field developed in the both field and armature and peak voltage is more so takes more current and fuse blow out, due to over current.
series motor rotate as repulsion motor with over current and commutation, but the core are not laminated, so it produce more heat.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
how to deside the capacity of chock for drive?
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
What is the Current equation in series RLC circuits.
HOW TO CALLICULATE RESITENCE,REACTANCE AND IMPEDENCE VOLTGE OF TRANSFORMER 13.33 KVA 144/240 VOLTS 93/56 A WITH FORMULA
How much load can take a 16 mm aluminum cable 3 phase
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
difference between the applicability of nortons and thevenin theorem
What is control system?
how to calculate slip ring induction motor stator and rotor currents??
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.
10 Mtr Hight of Lighting Arrestar how much area coverd??
