what is difference between short ckt and overload?
Answer Posted / naveen kumar
when two wire[p\n] is touch one to another is called short circuit and
when the give is extra load is called extra load
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
pls,send the previous year written test questions.
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
Which cable is use for rtcc control panel
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
why does a dc machine has high efficiency while working as a generator than as a motor ..
Earth leakage relay basic knowledge principle
Define rise time.
How to design the NGR Resistance
how to check three phase motor torque value?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
Why two phase welding machine is used instead of three phase welding machine.
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
Cb closed condition if there is a tcs fail whether cb will trip or not