Answer Posted / suresh
Deviation is departure from established specification where
as oos is out of specification means its failed
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
CAN WE DETERMINE THE PEAK PURITY IN GAS CHROMATOGRAPHY ANALYSIS?
why are measure gas flow " ml " in Gas chromatography
Which type of column should i use to check the purity of high molecular weight protein using HPLC reverse phase column chromatography? Hi everyone. I wanna to check the purity of high molecular weight protein (collagen) with MW of ~130 kDa using a HPLC. I know C18
How you develop a method in HPLC?
what is classification of elemental impurities? what is risk assement in elemental impurities?
if you have given a blank water how you analyse by general analytical techniques?
Why irmoisture balance is used for corrugated box moisture testing
how can I make the copper get white bye any salt or acit?
in dissolution why pool sample needed? in which type of drug pool sample need?
If we have 5 strength which is not dose proportinate and excipients also diffrent in each strength then how we can proceed for Force degradation? and excipient are same but not dose propotinate the how FD?
why sre you used Potassium hydrogen phthalate in standarisation of 1N NaOH and 0.1 N Perchloric Acid?
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
Explain the relations between number of carbon atoms in alkanes and retention time ?
How do we get end points and how many end points are possible for citric acid and di-acid not theorotically answer should be given practically.
How much is the standard area for glc analysis