it says in neutral wire current flows under normal condition,
but when we put tester it wont glow, why?
- 7 Answers
- 7791 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / vikram
Tester glows between phase & earth, when the circuit is completed through our body to earth. But since the neutral & earth are solidly earthed on Transformer secondary side so the neutral serves as earth, though the current in neutral is there because of imabalance in phaes.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain (in simple ) - root mean square. whats its role in electrical fundamandal.where its used
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
Transmission through a short line depends on
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
What is the transfer function?
how do you test tachos and servos
What are the advantages of stationary armature and rotating field system?
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
what is ps impedance test
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
how to select electronic timer(Star-Delta) setting for diff. rating motors
difference between main metering kiosk and check metering kiosk
