Interested to Buy Any Domain ? << Click Here >> for more details...
i want the equation of this question.
Tranmitter range is 120 mmwc and dcs flow range is 1700 nm3/hr. if i want to change dcs range from 1700 to 2400 nm3/hr then how much dp i have to enter in transmitter
- 2 Answers
- 12948 Views
- GMR, I also Faced
- E-Mail Answers
Answer Posted / alim
I think the equation is not straight forward, you need some repetition formula for calculating this.
Normally, I will use some software to do this kind of calculation such as InstruCalc. The data that you presented in the question is not enough. I am assuming that you are using the orifice in as the flow element, then you still need viscosity and specific gravity of the fluid.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how to calibrate steam control valve in steam turbine
What is ultrasonic flowmeter?
Explain pH, Conductivity.
What is mean by analytical instrumentation?
Valve positioner and actuators in detail.
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
How to Calibrate Vibration Probe (Axial, Redial) in field
it is possible to check the fail safe condition in pressure transmitter. if possible how?
In which principles tx ,pressure gauge,Temp gauge,control valve works?
what is actual drum level and compensated drum level?
where proximity sensor installed on tank in loading arm application
draw shematic diagram of c/v positioner(smart type)?
How digital input and digital output 's are working in dcs
plz send me general of ongc
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
