Interested to Buy Any Domain ? << Click Here >> for more details...
HOW MANY EARTHINGS REQUIRED FOR GENERATER
- 10 Answers
- 18839 Views
- Juniper Networks, I also Faced
- E-Mail Answers
Answer Posted / bhasker reddy
Depends on the KVA rating of generator earthing are required.
less than 40 kva atlest 2 earthing(one neutral & one body earth). more than 40 KVA 4 earthing (2 neutral & 2 body earth). if KVA rating increased should increase earthing.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate micom relay earth falt time and current sertting
what is cause of static electricity? I experience shock when i touch metal equipment in a room ,furher check shows earth leakage showing 80ma at the DB near to the 400 MCCB?
The loads are connected with phase and ground then why current flow as the loads ?
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
what is meant by power and distribution transformer ?
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
how much LT load can bear by the 100 KW HT connection.
What do you understand by oldham's coupling ?
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
Define demand factor?
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?
