it says in neutral wire current flows under normal condition,
but when we put tester it wont glow, why?
- 7 Answers
- 7789 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / sheikh
in single phase circuit we can checked neutral current by
clamp meter and approxe same current passing through in both
neutral and phase wires.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
please give some hindalco placement papers for written exam
What is difference between insulating medium and fault current interruption medium in a switching device.
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
How much of the total hydro power potential has been exploited so far in india?
what is reverse power relay brief explanation and in b/w where it is connected
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
What is transient response?
tan delta equation test on alternators
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
What does quality factor depend on in resonance?
how does the thyistor work in dc drive?
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
