how much binding wire is required for one tone steel
- 20 Answers
- 64395 Views
- Gammon, Hinduja, Jindal, I also Faced
- E-Mail Answers
Answer Posted / kapil jain
approximate 7 to 10 kg per ton binding wire required. it is depend upon the Design of
Steel Reinforcement & Diameter of Bar To be Binding.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Bitumen grades are 30-40,60-70, 80-100. what is mean by 30- 40
how many re use can use shutting material. timber ? ply? steel? plastic? fibre? aluminium? Doka?
how to calculate rate analysys of 1:6 plastering 10 sq m
how can can column be corrected when the design is not safe ? is the increasing the clearcover a solution?
What in your opinion makes you the most suitably qualified candidate for this post of civil engineering technician?
cement required for construction of 400mm*200mm*200mm concrete solid blocks for 1sq.mtrs,how?
what is yield and tensile strength of steel, if steel has yeilding strength of 60 psi than how much its tensile strength?
how to calculate the dry wt of sand and cement for a required design mix?for ex:M20
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
load combinations how many types for staad design purpose?
i have applied 40mm spacer in the concrete for tie beam. is it correct? kindly give me if there any code available
What are the different theories of failure under static load?
in one SQM plaster how much Cement and sand consumed in ratio 1:4
what is the max. area can we apply the plate load test ?
why do we provide haunches in rcc box or underpasses?
