Interested to Buy Any Domain ? << Click Here >> for more details...
if one potential missing in energy meter , how much % slow
the energy meter?
- 1 Answers
- 5696 Views
- NTPC, SK, I also Faced
- E-Mail Answers
Answer Posted / raul
If the potential coil is missing then the meter reading
will not advance i.e. the meter reading will stop
incrementing as the rotation of the energy meter disc is
dependent upon the interaction of fluxes created by the
shunt and series magnet with each other's induced current.
And when the flux created by the potential coil is absent
then the deflecting torque would be zero and hence the
rotating disc will not rotate.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
Mention the disadvantages of low power factor? How can it be improved?
Difference between a pilot wire and a normal conductor?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
why we used ZNO in Lightning arrester.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
WHAT IS THE PARTIAL DISCHARGE TEST?
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
how load of a turbo generator can be increased
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
What if the difference beween internal and exrteranal LBB?
