Interested to Buy Any Domain ? << Click Here >> for more details...
suppose, after calibrating a transmitter we fixed it in a process line. At live zero condition the Tx shows 4.5 mA. what should we do to make the Tx show 4 mA? If we adjust zero, will it not affect the calibration?
- 4 Answers
- 8145 Views
- ABG Shipyard, I also Faced
- E-Mail Answers
Answer Posted / rajesh
After the transmitter calibration they already fix the
transmitter on the prosces line. that time u check the
process line how mach pressure and check the 5 way manifold
condition and check the LP side impulseline chook. if its
ok manifold and impules line; open 5 way manifold equlizer
valve close any one hp or lp isolation valve that time tx
should be show zero 4ma. not showing 4ma. trim it zero.
zero not trimed cheange the transmitter.
Importent.
check the LRV how much its Zero Or not.
and check the wich type of transmitter.
if it is level transimtter that one different type of
callibration. check the where using the prossce line.
thank you
rajesh
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is first echo & echo window in radar type level transmitter?
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
please send data bank of quetions answers on analytical instrumentation.
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What are different type of instrument cable
send me HPCL paper
What is force balance principle? State some of its’ advantages.
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
what is performance test.need defination
Why MUX JB's are using only Temperature Element in Fundation field bus?
What are advantages and disadvantage of the ac supply load cell?
