Interested to Buy Any Domain ? << Click Here >> for more details...
Profibus DP is a multi-master system. Would it work on RS-485
4W or not, and justify your answer
- 1 Answers
- 10068 Views
- EIT, I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
The Profibus DP specification defines the hardware transport
physical layer as 2 wire RS-485. The communications
protocol and the transport layer are both part of the
Profibus DP specification (the separate 2 wire cable for
24Vdc power supply is not involved with the communications).
Any device that passes Profibus DP certification will
conform to the Profibus DP specification.
Therefore, a 4 wire RS-485 device will not work on a
Profibus DP network because it won't be a Profibus DP
device, it does not meet the Profibus DP spec, which is 2
wire RS-485.
Attempting to operate a 4 wire RS-485 device on a Profibus
DP network will only disrupt Profibus DP communications on
the network.
Carl Ellis
Measure First
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what is sliding spool valves?
Using your own examples solve a problem involving normal table. (experimental method and analysis)
What do you know about gail?
Turbidity analyzer working principle ?
what is the imbustion control loop
I have completed B.E. Instrumentation & control in 2009. i have 3 year industrial job experience in chemical plant.now, I want to join M.E. in external. so, Plese say easiet way and good institute name.
why we are using magnet for calibration of gas detector?
how to turbine speed measurement?
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
Name different types of bourdon tubes.
draw the block diagram of a level transmitter ?
explain key exchanges in all security modes WPA,WPA2,TLS?
Why MUX JB's are using only Temperature Element in Fundation field bus?
What is the difference between modbus,fieldbus & profibus
