We use ACB in LT and VCB in HT.But if we use VCB in LT and
ACB in HT that what will be the effect on the system or any
power range?
- 6 Answers
- 32261 Views
- Honda, I also Faced
- E-Mail Answers
Answer Posted / jithin
VCB is designed for HT it has vaccum chamber that prevents arcing and it triping speed is higher
ACB is desined for LT the terminals are almost open to atmospere it can cause flashing if we use it on HT
| Is This Answer Correct ? | 32 Yes | 0 No |
Post New Answer View All Answers
how we can calculate 2 phase welding transformer rating or total power?
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
how to calculation increase power factor for single phase
What is the power requirement of tamil nadu for one month?
please give some hindalco placement papers for written exam
what does mean of RCT and STR in diffrential CT?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
what do you mean by class PS CT and what are technical details needed for calculating it?
what are the analog quality input for protection function?what are minimum reqiments?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
what will be the min and max voltage flow from neutral to earth?
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
Briefly describe your ideal job?
