Why three wire is using with a RTD?
- 3 Answers
- 10978 Views
- ABB, MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / maswood alam
Actuly there is little diffrence b/w 3 wire nd 4wire, 3wire
has 95% accurcy nd 4 wire has 100% but 4 wire more costly nd
both are use as long distance so we genarally prefared 3
wired RTD System......
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
plz send me general of ongc
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How to Calibrate Flammable gas detector in field
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
Explain bernoulli’s theorem. State its application.
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
What is the start up procedure of desalter
Where is wet leg is used?
what is the process for double acting cylinder pneumatic for 32' v/v
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
How do bending tubing provide better measurement than using tubing fittings such as elbows?
Difference between ultra sonic flow meter
How to check vortex flow meter is in good condition while we do not having calibration setup?
