KVA transformer of different frequencies of
50hz,100hz,500hz&1000hz. which one of these transformer has
big size? Give reason
- 4 Answers
- 6599 Views
- Suzlon, I also Faced
- E-Mail Answers
Answer Posted / uma
inductive reactance is proportional to frequency and inductance. So for same inductance if frequency increases L can be decreased. where L is prop to volume. So higher the frequency lower the size required.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
What is rotary phase converter?
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
what is the need of starter in tube light and what type of starter is used in that?
How to calculate loses in transformer of 160 KVA ?
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
What is the reason that the humming sound is coming from the induction furnace panel?
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
How i can calculate current of cable according to ares?
what are the effects when a salient pole alternator is run at high speed like 3000 r.p.m?
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
