Interested to Buy Any Domain ? << Click Here >> for more details...
What is the output of 25 kva 11/.4 kv transformer in kw ? Plz generalized
it...
- 3 Answers
- 9118 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / s girish kumar
The Output of the transformer depends on its load .,means whether it is capacitive or inductive.,But approximately we will take the powerfactor as 0.8.
So If 25 Kva transformer then it is 25*0.8=20KW.It means maximum we can supply this much of consumers
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
What is quadrantal symmetry?
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
Difference between rating factor of cable and derating factor of cable?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
What is different between Difnit time and instatous over current relay
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
What are dcs and plc?
What is steady state response?
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
What is electrical diversity factor in electrical installations?
