Interested to Buy Any Domain ? << Click Here >> for more details...
we convert 66kv to 33kv then 33kv to 11kv,11kv to 440v.why
not we convert directly from 66kv to440v?
- 7 Answers
- 20687 Views
- HCL, L&T, I also Faced
- E-Mail Answers
Answer Posted / ved prakash
Basic insulation level at HV & LV side is also a big factor.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What kind of maintenance is conducted for Transformer
How to discuss the phase shift of transformer considering open delta?
what is the use of vcb & isolator in substation?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
What is the test block protection relay if any body know plz explained
why HT armoured cable does not glanding
What is different between Circuit breaker and Isolater?
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
Name a govt approved university which have 100% online engineering course.
before synchronizing an alternator,power factor is leading ,why?
what is a vector protection in transformer
