Interested to Buy Any Domain ? << Click Here >> for more details...
how tubelight circuit is connected and how it works?
- 7 Answers
- 54885 Views
- Punj Lloyd Ltd, I also Faced
- E-Mail Answers
Answer Posted / ramesh gm
tube light connected sires supply 230 volt single phase
phase terminal connect switch to choke one end terminal
other terminal connect tube light one end 1st terminal other
connect the stater sires tube other side pin terminal last
terminal connect the nuteral terminal
Working:
choke is used to get high voltage for produce electron
between filaments and mercury combination..at the time
starter working as a switch..when the light illuminates then
the starter disconnected due to inefficient voltage..(at the
time flourescent acting as a starter)
| Is This Answer Correct ? | 9 Yes | 3 No |
Post New Answer View All Answers
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
Describe the control mechanism of missile launcher???
how we can set the IDMT relay.
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
How can a equal potential zone be carried out in conductors?
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
wat is the first thing dat is needed, 2 lay a cable in some area??
What is voltage divider rule?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
how the phase convertor changes the no. of phases
how many current required for hypo test
grr resistance & contrator malt continuous
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
What facility we get after CT secondary earthing and how?
