In Bulkdensity What is the difference between USP-I and USP-
II
- 1 Answers
- 4270 Views
- Reddy Labs, I also Faced
- E-Mail Answers
Answer Posted / moon
USP I HIGHT (UP & DOWN) IS 14mm
USP II HIGHT (UP & DOWN) IS 3 mm
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
The use of vermilion on rubric of the Tartar Relation is confirmed by the presence of three lines attributed to HgS. Why should this diatomic have more than one vibrational line?
what are UV rays absorbs slightly?
what kind of question can be asked in interview for UV- VISIBLE & give me answer ?
What is the requirement to give RFlow when using RID detector?
The rate constant for the second order reaction is 0.54/M.s at 300oC. How long (in sec) would it take for the concentration of NO2 to decrease from 0.62M to 0.28 M? 2NO2(g) 2 NO(g) + O2(g)
How to accelerate electron capture decay?
what is induction on electrical insulators
During Soundness testing of Cement by Lechatelier method the Cement mould expands about 20 mm when merged in curing water for 24 hours after mould preparation.In that Cement MgO content is about 3.0%,SO3 is about 2.6% & Blaine is about 360 M2/Kg.Guess the reason & suggest solution.
what does 50 denote in dowex 50 ????
In testing of Cement the formula for water requirement for setting time is as below- Water required for setting time = NC x 0.85 The question is that what is the logic of 0.85 in this formula??
How can be set a responds factor for evaluating a unknown impurity by HPLC
WHAT IS THE SYLLABUS OO GROUP -I?
Normally entropy is expressed as q/T. But, work and heat have same unit. Why can't it be replaced by work?
what is the difference between elctrefining and electrolysis?
Why does the experimental lattice enthalpy of NaI differ greatly from the theoretical lattice enthalpy?
