Interested to Buy Any Domain ? << Click Here >> for more details...
verification of wave number why you are use in IR calibration
- 2 Answers
- 8254 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohit kumar
4000 cm-1 to 625 cm-1
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which products will produce when acetic anhydride reacts with Ter-butanol, Sec-butanol, Iso butanol, Dimethylamine etc.
What is the purpose of octyl silane columns?
if you get peak in blank then what require to do?
What if impurity area in control sample coming more as compared to LOQ level of impurity ?
if identification threshold crosses the limits then what next step?
in which situation require to change rs specification?
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
What is importance of pH in the Heavy metal test and How it effect on the test results?
What is similarity factor?
1.What is the difference between method validation and method verification 2.Which guidelines proposed to method transfer
What should be the level/ Percentage of Arsenic in Arsenic free zinc.
What is split ratio in Gc? Splitless? how requirr to select?
How to determine the EDTA content by potentiometry titration in Ceftriaxine sodium
How to set analyticl specification for combination products?
What is dose dumping? why require to do?
