Interested to Buy Any Domain ? << Click Here >> for more details...
why Copper loss is represented as I square R ?
- 5 Answers
- 12052 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Read above as ' Pd V across a resistor= I(amp) x R (ohm)
volt.Power = V x I = I^2 R watt' ( As pd is measured across
the resistor ,the pf is unity)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
On what principle electric motor works?
how you taken aotitude test
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
how could we know the size of cable by physical view?
What is the meaning of HT Trivector Meter ?
what is the difference between online & offline caliberation of KWH meters. Can Digital meters be caliberated
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
HOW TO CALLICULATE RESITENCE,REACTANCE AND IMPEDENCE VOLTGE OF TRANSFORMER 13.33 KVA 144/240 VOLTS 93/56 A WITH FORMULA
How to select HT/MV cable size ?
why electronic instruments is more favorable than electrical?
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
can u please mail me the syllabus for GET exam for damodar valley corporation?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
