Interested to Buy Any Domain ? << Click Here >> for more details...
In a thermal power plant ID Fans running with full load but
boiler load is only 80 % give reason ?
- 9 Answers
- 19527 Views
- Essar, Prumatech, Tata Power, I also Faced
- E-Mail Answers
Answer Posted / lalitshukla
there are many reason for that.
1. furnace or any duct of flue gas leakage.
2.deposition on super heater which clog the passage of flue gas
3.density of fuel below required density of boiler fuel
| Is This Answer Correct ? | 22 Yes | 3 No |
Post New Answer View All Answers
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
what is the basic use of power plant in equipment
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
LAPT working in alternator / generator
What is difference between secondary Air & Tertiary Air and Their use.?
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
By any way can we increase the B check hours from 300 to 500
why airtel use + 24 volts and other operators use -48 volt
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
what is the trip circuit supervision in an electrical meaning?
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
what is restricted earth fault explain in details
what is natural frequency of turbine shaft .
