Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nitish katoch
no we can we can only calibrate measuring devices..its
calibration is only depend upon its design
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
How to Calibrate Level Troll in field
kindly sent some demo question and answer
What is the constant voltage unit?
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
if my flow is 20000 m3/h than which range of DPT i have to use????
In turbine what does term CDP, NI, NH, HSSOC means.
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
