what is the difference
between lod and loq?
Answer Posted / kizar ahamed
LOD :LIMIT OF DETECTION , FOR THIS TEST NEED NOT TO BE
QUANTIFIED . IN THIS TEST WE MEASURE THE DETECTING ABILITY
OF THE SYSTEM.
LOQ: LIMIT OF QUANTITATION : FOR THIS TEST ,WE SHOULD
CALCULATE THE SIGNAL TO NOISE RATIO AND MOREOVER IT SHOULD
BE QUANTIFIED.
Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
how to selecet an exact coloumn for an new molecule development by hplc how to select exact salt as buffer for new molecule development by hplc what is the the process to select the mode of saparation of compoundes by hplc what is the use of ph of buffer what is use of buffer,ph,organic phase,ans methods how the molecules get saparated in coloumn,
why we should take dst factor for below 1%moisture samples
if tech transfer fails whay require to do?
if your impurity coeluting with each other in that situation how require to set specification? is it acceptable?
what is %labelled amount in content uniformity of dosage unit and its calculation?
What is the requirement for brazil in the analytical method vslidation comparr to ich?
What is aggregate and fragments in SEC?
If inhouse hplc related substance method is completly diffrent from Usp for finished proďuct with diffrent impurities then how require to prove method equivalecy?
Ratio of Water and Acetonitrile(diluent) is not recommended to use in cleaning method validation,why?
mahagenco syllabus for the post of chemist
Related substance method equivalency on control sample or spiked sample?
on the basis of bcs class how to proceed the solubility?
What is split ratio in Gc? Splitless? how requirr to select?
In rs method development when we are going area normalization method to dilute standard method?
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards