What is Procedure the procedure to select CT's & PT's in
66kV and above substation?
- 3 Answers
- 10374 Views
- Infotech, Vijai Electricals, I also Faced
- E-Mail Answers
Answer Posted / kbonn
For example u have 100MVA transformer 66KV line
your CT ration 100,000,000/1.7320x66,000=874.77
so you can used CT ration 1000/1A
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
2. What are the parameters of EHT sub-station?
what is the differance between HT motors And LT MOTORS.
What is tan delta & PPM in transformer? and whats its IS value?
is IS says that neutral should be brought to switch box. and this one is a recomended practice
how many types of motor can be used in washing machine
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating
electromechanical relay type identification example : type=tjmh t-stants for j- m- h-
why induction motors are rated at 0.8 power factor.
what is the prinsiple of dc motor and construction and working ,application of dc motor.
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
briefly explain the main blocks found in a microprocessor based system
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
How to calculate MCB Breaking capacity.
