Interested to Buy Any Domain ? << Click Here >> for more details...
it says in neutral wire current flows under normal condition,
but when we put tester it wont glow, why?
- 7 Answers
- 10104 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / liaqat ali khan
In Neutral Wire Current doest not flow, Neutral Wire is
used to complete the Electrical Loop Only,In normal cases
current flows in the live wire upto the load and then
dissipate engergy in the load in different forms and if u
check the neutral wire with Clamp Meter (Ammeter) u will
see Zero Current. I hope my answer will satisfy u.
Regards,
| Is This Answer Correct ? | 4 Yes | 14 No |
Post New Answer View All Answers
How to calculate VCB rating for 33KV ,25 MW Power line?
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
what is the difference between capacitive and resistive voltage divider?
how maney type tempereture measurement ?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
what are the parameters plays a major role in Potential transformer Burden calculation??
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
role of europe union in UK safety legistlation (electrical safety)
can u give me a brief idea about power line carrier communication ??
What the difference between ac and dc inductor an capacitor
What is the formula for calculating no-load current?
kindly send me 11KV MV motor differential protection procedure by primary injection method.
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
