Interested to Buy Any Domain ? << Click Here >> for more details...
what is the basic working principle of I/P and Positioner in
any control valve.
- 12 Answers
- 81268 Views
- Essar, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / mayank rathod
mA ---> Kg/Cm2 ---> % Valve Open
4 ---> 0.2 ---> 0%
8 0.4 25%
12 0.6 50%
16 0.8 75%
20 1.0 100%
| Is This Answer Correct ? | 36 Yes | 7 No |
Post New Answer View All Answers
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
is motorized valve closed when power shutoff?
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
How to calibrate level transmitter with use of HART?
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
What is 1:1 redundancy ?
Introduce yourself which is not present in your biodata?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
What is the difference between working pressure and calibration pressure of a control valve
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
