Interested to Buy Any Domain ? << Click Here >> for more details...
How do you reverse the direction of rotation of a FAN?
- 13 Answers
- 54890 Views
- CPCL, IOCL, I also Faced
- E-Mail Answers
Answer Posted / bala
what will happen if i remove the starting winding of fan
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
why constant voltage transformer should be start without load? and if started then what will happen?
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
why industry prefer ht motor instead of lt motor.
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
what is p.s impedance measurement test in earthing transformer?
Why the frequency of ac in india is 50 hz but in some other countries it is 60 hz.
How to calculate impedance volt in Transformer?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
