Interested to Buy Any Domain ? << Click Here >> for more details...
can we replace a pressure transmitter of range 0 to 25
Kg/cm2 by a Pressure transmitter of range 0 to 10
Kg/cm2 ?.. Will it affect 4 to 20 mA output signal which we
will feed to the PLC.
- 9 Answers
- 13552 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / dinesh kumar
Its not possible by answering without knowing the application
But in both the cases v can get the 4-20mA output
In case if the o/p doesnt goes beyond 10kg then v can replace and the o/p side of tx shud be calibrated before installing and the changes shud be entered on plc.
In another case if the user wants better accuracy he may b using 0-25kg/cm2 tx eventhough the internal pressure is b/w 0-10kg/cm2
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the minimum power (P=VI)to produce a spark?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
What is heating effect?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
principle of dead weight tester ?
why Fahrenheit unit of moistur analyzer transmitter
how to calibrate and troubleshooting of leveltroll?
What is the use of each wire in three wire RTD
what is the reason while warning lamp is on while the engine is cranking?
Which type of pressure can be measured by these elements?
Linear amplifier.
What you mean by multi stage control vavles?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
