Interested to Buy Any Domain ? << Click Here >> for more details...
When we will do simulation for I/P?IF WE DO SIMULATION through which way either series or parallel?
- 1 Answers
- 4579 Views
- TVS, I also Faced
- E-Mail Answers
Answer Posted / ilayaraja
simulation for i/p always done in pararel.if you r simulating with out removing the control room signal wires, u need to put your simulator in sink mode.sink mode means it uses the voltage in the loop
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is the reset offset and control system in instrumentation
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
Where is wet leg is used?
How to decrease opening & closing time of on/off valve?
typical loop drawing of a simple feedback control comprising of one transmitter and one control
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
What is modbus?
what is easiest way to read STL language in PLC?
what are the diff. in servo and regulatory control?
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
Manipulation of dead wt. tester double piston type.
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
What is eddy current? Describe the operating principle of proximity probe.
