Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / r.kumar
for megger test in motor.......we apply 500v DC supply at terminals and check:
1.phase 2 phase(ohms)
2.phase 2 body (>100MEGA OHMS OR GIGA OHMS)
3.phase 2 neutral(>1 GIGA OHMS)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
xfhnchncv?
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
what will happen if there is a voltage leakage or current leakage in an electrical train
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
Explain cmrr?
State nyquist stability criterion.
what are inherent currents?
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
What should be current in the Primary and secondary side of 1000KVA (11KV Supply)Transformer.?
I completed iti in2004 I was worked in A grade contractor can I get c licence
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
Define resonant peak?
How to assume answer to electrical questions
why zero sequence impedance measurement is not applicable for single phase GT
