Interested to Buy Any Domain ? << Click Here >> for more details...
why we use only sine wave in ac why we do not use other wave
forms
- 21 Answers
- 50195 Views
- BARC, NTPC, I also Faced
- E-Mail Answers
Answer Posted / vijaykumar
if we apply any wave form other than sine wave to the transformer the output is spikes due differentiation and devices dont work for those spikes and damage all home appliances so we use sine wave only
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
What is superposition theorem?
can we use engine degreaser for electrical motors?
what is circuit recombiner and how it is different from circuit breaker
What is pi controller?
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
What are the different losses In a de mac1une'! t.xplam
Percentage losses in power generation?
HOW TO CALCULATE EARTHING SIZING?
What are the different types of controllers?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
The principle of switching circuits for different types of batteries in application of storage systems
How to Make relay co ordination chart for a Electrical power distribution of a plant
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
