Interested to Buy Any Domain ? << Click Here >> for more details...
What is the SCAN time of a DCS/PLC? What is the typical
value for scan time of DCS and PLC?
- 6 Answers
- 51671 Views
- Essar, Gasco, Siemens, I also Faced
- E-Mail Answers
Answer Posted / purushotham
scan time , name it self indicates time required to scan the process of operation.
time taken to finish operation (reading inputs,logic(process) and execution (output) of results).
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
What are the types of valves?
How flow can be measured with dp?
Valve positioner and actuators in detail.
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
which processor is used in dcs.
Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?
Give Detail information about plc,dcs,and scada system?
what is isloted barrier how it works and what are the main purpose.how it make safe area.
What is mean by analytical instrumentation?
how to calibrate 0- 150 psi presure gauge by dead weght tester
Which type of pressure can be measured by these elements?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
