Interested to Buy Any Domain ? << Click Here >> for more details...
What is the standard height for stancion supports? and what
is the standard mounting height for different transmitters?
- 11 Answers
- 24624 Views
- Samsung, I also Faced
- E-Mail Answers
Answer Posted / yousuf
the standard height of the stanchion is 1350mm to 1500mm.At
this height only the maintenance crew can easily view the
transmitter.
(saudi aramco standard is 1500mm)
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Tr. Wiring for calibration.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How many ohms are required for proper earthing?
What is the purpose of LO Overhead tank in turbines.
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
Which topics are covered in Process Control?
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
How do bending tubing provide better measurement than using tubing fittings such as elbows?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Questions on flow meters,few questions on HART protocol,
Explain pH, Conductivity.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
What is the difference between modbus,fieldbus & profibus
which type of signal used in instrument?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
