Answer Posted / prasanth p.s
copper loss depend on current and core loss depend on voltage
there for total loss depend on voltage and current not on powerfactor .in other equpment like motor total loss depend on
powerfactor ie kw=(v*i*pf)/1000 .there for motor rated in kW.but tranformer rated in kVA because kVA=(v*i)/1000
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How isolater function when installed inelectrical 440V wiring
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
What are the different circuits in thermal power plant?
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
Define the term factor of inertia.
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
Mention the difference between Analogue and Digital circuit?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
describe the A.C. Generator Testing procedure
Difference between low impedance and high impedance Restricted Earth Fault
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
How to calculate the multiplying factor for energy meter with ct ratio given