What will happen if 230V DC motor connected to 230V AC
Supply?

Answer Posted / r.s. kushwah

motor will produce less torque, spark on commutator,

Is This Answer Correct ?    5 Yes 1 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring

1514


what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?

1825


What is the purpose of stablization resistor in high impedance bus bar protection

1538


what type questions asked in hp cl

1444


I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.

2384






How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?

4007


do you have some of interview Questions in power and genrator section in general whith answers

1646


what r the checklist while installing a 380 kva DG set

3328


Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?

1524


apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.

1729


I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???

2141


What is the magnetic field (coil DC ) of Turbo Expander?

1591


I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA

2541


Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?

1562


What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?

1511