Interested to Buy Any Domain ? << Click Here >> for more details...
Why OSI layers having 7 layers instead of one layer.
- 8 Answers
- 16292 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / santosh
* Standardizes the N/W components to allow multiple vendor development & support.
* By breaking into 7 Layers to make learning easier.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
Define the virtual channel?
When ospf protocol advertise its routing table?
In which protocol supenetting is enable by default?
How many ports are present in a router?
Which mode we can't skip when we come back from interface mode?
How does rip differs from igrp?
What type of transmission bus topology support?
Define logical topology.
In how many ways you can access router?
What is loop back ip in ipv6?
What is ad in ccna?
Which LAN switching method is used in CISCO Catalyst 5000?
Explain what is formula of hold down time of eigrp protocol?
Suppose we have some switch in network and we are running RSTP how much convergence time will be there if one link down
