Interested to Buy Any Domain ? << Click Here >> for more details...
we convert 66kv to 33kv then 33kv to 11kv,11kv to 440v.why
not we convert directly from 66kv to440v?
- 7 Answers
- 20664 Views
- HCL, L&T, I also Faced
- E-Mail Answers
Answer Posted / yogender goel
It increases the power transmission cost very high.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
What is trip and closing coil in cb? Why need of them
Why mostly the HV side of transformer has Delta?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
Load transfer in 11kv double busbar switchgear - operation.
Why is negative feedback invariably preferred in closed loop system?
what is the requirement regarding earthing of Single conductor with AWA
whatis the commertial spec. of distribution boards ?
I am having a 42KW 3 phase electrical heating furnace, heating element is 80/20 nichrome material, my connections is made in such a way that 2 star connection compromising 2 coils per phase so totally 12 coils, shall if i use it unbalanced star condition (instead of 2 group of 3 phase or 1 group of 3 phase, connecting 4 phases of 5 phases) what will be the consequences and is it acceptable?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
design of IGBT firing circuit for 11KV
State any two nuclear power stations in India, with their generating capacity.
Write the programming software name for LG, SIEMENS,Messung,AB
Why cables and busbar both needed in LT Panels?
