why we step/down voltage in multipul of 11kv?
Answer Posted / eeecruxkarthik@gmail.com
incoming supply is 11kv but outgoing is 433v only
transformer tapping is constant 3rd mode this is for
electricity stsndards
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What happen when change order of CT in GIS feeder?
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
what id a dry type transformers and its function ?
how to compute kvar in substation feeder to improve power factor and sending voltage
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
What is pd controller?
how many single tension hardware are required on a double circuit transmission tower?
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
Can you explain about Restricited earth fault protection scheme
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
Q) Write VBscript code along with QTPscript code in QTP tool for below scenario 1. Launch yahoo site(i know) 2. Do loogin(i know) 3.Click inbox link(i know) 4.Go to every page of mail box and count no.of read mails and no.of unread mails(i know) 5.Store page numbers, read mail count and unread mail count in a new excel file sheet 6.Create 10 types of graphs on that data 7.Do logout and close site(i know) 8.Save new excel files with graph
why capacitive load is not used in routine life????any reason is there ??????