What are all the possibilities discharge will be low in the
pumps?
- 12 Answers
- 20322 Views
- JSW, I also Faced
- E-Mail Answers
Answer Posted / chuck cowlagi
Without a reference to a specific type of pump,the question
is incomplete.Question should be correct to expect a
correct answer!
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
If we heat the rod what will happen,draw stress & strain curve before after heating ?
Is Solid work and solid edge best programs for drawing? what is the difference bewteen them? r there better softwares?
What is the use of divider?
What are the causes of damage to propellers?
sir iam vinod kumar i have done B.TECH. in mechanical engg in 2007 i want to choose career as section engg.please give the information about coaching institute.
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
One litre is equal to ________cm3 ?
i want to jspl Q&A,pls send this email id:var05mech@yahoo.co.in
What is an expansion valve and its purpose?
What kind of pipes are used for steam lines?
Assume a DC motor with the following parameters : Motor torque control = 0.0848 Nm/amperes Back EMF control = 0.0848 Volts/(rad/s) Armature resistance = 0.75 Moment of inertia = 0.00001696 kg/m2 With zero frictional load and taking a feed forward gain of 2, determine the motor response for a unit step function. please forwaded the answer to the below mail id thanks in advance Regrads, peer_kaba@yahoo.co.in
What is hertz in electrical system?
about basic questions ofpiping engg
in aviation, How does control valves work?
How much is 1 kn in kg?
