What type of isolation transformer used in UPS's??
It's Star-Delata Or Delata-Star????Why it is used????
- 6 Answers
- 17842 Views
- Emerson, I also Faced
- E-Mail Answers
Answer Posted / hussein
Delta-Star
reason: isolation transformer is to isolate the neutral.
However, the transformer input will be only 3 core cable
(RYB phases) which will be connected as delta, output will
be 4 cores (3 phases and one neutral) and clean earth which
will be commoned to neutral at the star point.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
hi can anyone pls tell me the eee interview core questions asked in l&t
What was your role in the silicon evaluation/product ramp? What tools did you use?
please send me previose rrb junior engineer qustion papers
Circuit diagram of tube light without starter using electrical choke
What products have you designed which have entered high volume production?
what will happen if synchronous machine rotor fed from single phase ac supply
Electrical Engineering
How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......
Draw a block diagramof Three UPS systems connected in Parallel mode?
What are the different methodes for calculating the short circuit Current?
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
