What are the difference between off-load tap changer and
on-load tap changer in transformer?
Answer Posted / vinoth kumar.n
In off load tap changer the transformer will be in off
condition,it safe for equipment and personal safety,,
In on load tap changer the transforme will be in running
condition,there is no interruption of power supply,but
there is unsafe for windings.
Now a days 230kv are and above prefering only off load tap
changer,The tap changer provision will be held on HT side
only.
Is This Answer Correct ? | 3 Yes | 7 No |
Post New Answer View All Answers
How to assume answer to electrical questions
How to Calculate KA Rating of Main LT Panel
Why computer humming sound occurred in ht transmission line?
can i use the six sigma method which is used in management area, in state estimation of power systems?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
some basic standard questions on transformer.
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
which type of cabel
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
what is the differance between HT motors And LT MOTORS.
Post possible questions for Power Factor Panel FAT / SAT