Interested to Buy Any Domain ? << Click Here >> for more details...
What are the difference between off-load tap changer and
on-load tap changer in transformer?
- 2 Answers
- 18434 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / g.trinadh
In off load tap changing transformers tap is changed after discharging of load on LT side where as in on load tap changing transformers tap can be changed with out discharging load on transformer.
| Is This Answer Correct ? | 17 Yes | 1 No |
Post New Answer View All Answers
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
what is efficient motors and how it is different from normal induction motors
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
whit is 33kv power 300*300 cable full current with formula
What is inverse definite minimum time lag relay? Where is it use?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
use of choke in APFC panels
How equivalent impedance is calculated in thevenin theorem?
new 90kw motor installed so how I purchased cable ,fuse,etc please give me technic for cable selected why always capacitor delta connection
what is the use of Auto re-closer?
How many VSC based HVDC are there in India and the world
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
Why is negative feedback invariably preferred in closed loop system?
