you are working as a QC in hihg rise building. when what"s
ur responsibilities works?
- 3 Answers
- 6426 Views
- Punj Lloyd Ltd, I also Faced
- E-Mail Answers
Answer Posted / jeyakumar
Refer Projects quality plan and do the job.If any
deviations found inform site engg/incharge and do rectify
and redo the same as per PQP.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the use of extruded feature in solidsworks?
How do you maintain water pressure?
how to calculate rate analysys of 1:6 plastering 10 sq m
Which percentage of carpet area use in plot area of office building.
Can rice husk ash be used instead of coal fly ash for manufacture of clc/ foam concrete
100mm block work 64 bags of cement used 150mm block work 286 bags of cement used 200mm block work 20 bags of cement used patly work (M15) 293 bags of cement used mortar ratio is 1:5 how to calculate volume of sand in cum & no. of bags
what is the tensile strength of 10swg and 8swg gabion wire?
how to calculate reinforcment in staircase cranked beam?
what is tension & compression of steel bending.
1m square 20mm plastering how much of water need curing work
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
what is the minimum cement content for M20 & M25 as per is code -456(2000).
What is the standard specification of MOR and Water Absorption of Homogenous Ceramic Floor Tiles?
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
How to determine thee cut length for steel reinforcement bars in R.C.C design
