Interested to Buy Any Domain ? << Click Here >> for more details...
DG B-check,C-Check,D-check is depending upon the running
hrs.If the running hrs is not reached as mentioned.How to
conduct the DG checks.
- 15 Answers
- 59761 Views
- Blue Star, I also Faced
- E-Mail Answers
Answer Posted / mayank sharma
DG Checks are depand upon running hours but if running hours is not reached then we should conducts checks as per the time duration as listed below :
A Check - daily
B Check - 300hrs. or 6 months( filter change, lube oil change)
C check - 1500 or 1 year(A+B checks+ injectors & turbo charger cleaning )
D Check - 5000 hrs. or 2 year( A+B+C Checks+ Tappid setting )
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
in parallel operation of power transformer why the distance between power transformer and capacitor bank feeder is necessary to know
Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
Why air circuit breaker off due to power failure?
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
i want to apper for apgenco or aptransco or related can any one sugest me where can i get previous papers of thouse exams
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
How to design the NGR Resistance
why the rotor current becomes in steady state during high slip region? please verify with equations.
How much load can take a 16 mm aluminum cable 3 phase
