How to calculate busbar size & what is the procedure we
make for determine that?
Answer Posted / dubai
The bus bar size normally for copper 1sqmm=1.25Amp and
aluminium is 1sqmm=0.8Amp
Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
Is there any specialised book to refer about fault level calculation both in MV and LV side??
george phenomenon of synchronous machine
how to calculate transformer load?
How to calculate earth wire load by formula
Write down the brushes of a de machine.
can some one clearly explain why -48 volt DC use in telecom site????
why swityard is necessrry requirement in any bis power distributin systems?
Hi everyone. Some Generators uses 3-Pole breakers with extra contactors for Neutral. Some uses 4-Pole. Why so? What is the idea behind this? Thanks in advance for the solution. Kr.
What are the two basic types of transformers?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
how to calculate fault level?
What is called limb of a transformer?
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
send me all basic electrical question and answers
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%