Interested to Buy Any Domain ? << Click Here >> for more details...
What is Hi-Pot Test for Grid Station HV Equipments?
- 2 Answers
- 8200 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / shao
Thank you so much Naresh!
But i think we only measure the respective leakage current at that phase on which we have applied voltage.?
e-g; Applied 40KV at Red phase for 60sec, & measured leakage current was 0.6micro Amperes.
Actually im seeing this testing at a 132KV Grid Station.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What are the two basic types of transformers?
What is George phenomena to start the synchronus machine?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
What is DC series motor?
How to design the NGR Resistance
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
what is consequences of neutral and earth connect?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
How can I calculate the Mega watts required to run a plant having many electric motors and other electrical components.
Why does curving the pole faces in a dc machine contributes to a smoother dc output voltage from it?
What is earth?
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
trasnfarmaer core make
