Interested to Buy Any Domain ? << Click Here >> for more details...
how to check thermocouple ,its working or not?
- 14 Answers
- 52026 Views
- Coca Cola, Ford, Honeywell, I also Faced
- E-Mail Answers
Answer Posted / gobi,kgm
Check coninutity and ohms it comes t/c is good.if it is not
t/c is dead.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is three element drum level control system why its better than single element?
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
the output of the common trasmitter protocol in qatar gas are the following
How to fix back the valve actuator stem
What is limitation of the ht.of the displacer of a level trol?
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
Why is the orifice tab provided?
Coal mill Instruments Equipments for cement plant And process diagram ?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
What is zener diode? What is voltage regulator?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
Why plc require in analog input 4-20amp & 0-10 volt?
