Interested to Buy Any Domain ? << Click Here >> for more details...
What is the formula to find out the kvar required to
improve the powerfactor from .85 to .99 at 1500kw, 415v.
- 4 Answers
- 19584 Views
- Trident, I also Faced
- E-Mail Answers
Answer Posted / waqi
first calculate the kva at .99 and 1500kw
(cosp=kw/kva),than put the value of kva in this formula kva=
(kw)2+(kvar)2)^1/2 to caculate kvar at .99 pwr factor
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why should the primary of transformer be connected in delta in a heat run test?
What is earth system using on the floater TN-S or TT. Iam not sure and what ICCP
what will happen if ac and dc supplies given
What is the need of generator relay panel
what is the isolation transformer. what is the isolator?
why ct ,cvt should be stored in a vertical position?
Load transfer in 11kv double busbar switchgear - operation.
What is a feedback in control system?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
please give me all the Alarm .Trip ,Safety Relays & Conditions of Chiller mail me on ashokbabunhce@gmail.com
what is RFID? thire application;
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
What do you mean by cogeneration? What its working principle?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
