Interested to Buy Any Domain ? << Click Here >> for more details...
what is brushless generator.How does work it..??
- 3 Answers
- 9049 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / shiv shankar
the exicter is coupled to the generator shaft. the exciter
carries the permanent magnet gen., ac gen., diode wheel
arrangement for rectification and dc generated is directly
fed to rotor via internal contacts through shaft hole
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
How many types of losses occur in a transformer?
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
what is there inside an inverter and how it works?
SUTIABLE FOR ohm's law super conductor
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
can anyone provide me a amf panel control wiring using ec-2 relay?
How to determine stage of Automatic Power factor controlling Relay(Apfcr)?
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
Why using synchronising methed in DG's sets?
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
